WIRTHCO BATTERY DISCONNECT STOP-K MASTER SWITCH
$31.95
11756
Key is removable in OFF position. At 12 volt: 1,000 amp surge, 100 amp continuous. At 24 volt: 500 amp surge, 50 amp continuous. With extra key, waterproof cap. 3-1/2" x 2-1/4".
|
TAPA-CIRCUIT WITH DUAL FUSE HOLDER
Turns one fuse slot into two. Plugs into occupied or vacant energized fuse block slot. Provides one fuse holder to protect existing circuit, and a second fuse holder for new circuit. 10-amp rating at 12 volts. 16-gauge lead for new circuit is 5" L includes insulated crimp-type coupler.
TAPA-CIRCUIT, FITS: MINI FUSE BLOCKS $13.99
|
WIRTHCO DISCONNECT SWITCH WITH FUSED BYPASS
$17.39
11758
To disconnect power, loosen green knob, or for anti-theft, completely remove. 6, 12 or 24 volt. Rated at 125 amps continuous, 500 amps surge. Fits top post batteries. This switch allows the battery to be disconnected without disrupting computer settings. 15 amp bypass fuse maintains trickle current to radio, clock, etc. U.S. patent #397,091 Size: 3-1/2" x 1-3/8" x 1-1/4".
|
BATTERY TERMINAL
$2.59
11895
Marine Terminal w/stud. Each.
|
BATTERY BOOSTER CABLES
$37.95
12705
Booster cables fit both post and side terminal batteries. Easy-grip low profile clamps attach easily in hard-to-reach battery situations. Dual, tangle-free cables are 100% copper. 12' cables.
|
WIRTHCO SAFETY/SWITCH BATTERY DISCONNECTS
$41.95
13250
The easy way to disconnect electrical power on any vehicle. Without tools. Simply lift the knife; power is cut. Prevents shorts and fires when working on electrical systems; discourages theft; eliminates battery drain on idle batteries. For Negative or Positive Top Terminal Batteries
|
SAFETY SWITCH IN-LINE DISCONNECT
$35.95
14649
Mounts under hood or other location. Run a new cable to the switch, connect the battery cable to the post on the switch. Does not attach to battery. For permanent installation where disconnection of battery power is desired near the operator, or hidden as a theft deterrent. Capacity is equal to a #1 AWG battery cable; for all voltage systems.
|
DUAL BATTERY SWITCH 3-POST
$27.39
55-8989
Have one battery for starting and one for auxiliary power. Provides full-time charging for both batteries; will not run down the starting battery. 12 volt DC continuous duty. Cadmium plated, non breakable heavy duty housing includes terminal nuts & washers. 80 amp continuous service.
|
TWO BATTERY STANDARD ISOLATOR 70 Amp CS
$44.95
15776
When 2 or more battery banks are in a charging system you can get stuck with dead batteries and an engine that won't start IF YOU DON'T HAVE a battery isolator. SOLID STATE ELECTRONICS means no moving parts to wear out! UNIQUE DESIGN: The anodized fin design provides maximum heat dissipation plus all electrical parts are sealed with a moisture proof epoxy sealant to preserve them from the elements. ALLOWS EACH BATTERY TO DISCHARGE AND CHARGE ACCORDING TO ITS OWN NEEDS.
|
PERKO BATTERY SELECTOR SWITCHES
$48.49
750277
Selector switch for start and operation of both batteries in parallel. "Off" position is also emergency disconnect in case of electrical problem. Surface mount, copper contacts, brass terminals. 250 amp continuous, 360 amp intermittent.
|
UNIVERSAL AUTO TERMINALS
$16.99
751660
Heavy duty clamp terminals. Battery terminals on a display card of 10
|